Funny

14748 readers

2359 users here now

General rules:

Be kind.
All posts must make an attempt to be funny.
Obey the general sh.itjust.works instance rules.
No politics or political figures. There are plenty of other politics communities to choose from.
Don't post anything grotesque or potentially illegal. Examples include pornography, gore, animal cruelty, inappropriate jokes involving kids, etc.

Exceptions may be made at the discretion of the mods.

founded 2 years ago

MODERATORS

TheDude@sh.itjust.works

kersploosh@sh.itjust.works

example@reddthat.com

VicksVaporBBQrub@sh.itjust.works

392

Where do you see yourself in 5 years? (lemmy.ml)

submitted 7 hours ago by cm0002@libretechni.ca to c/funny@sh.itjust.works

24 comments fedilink hide all child comments

you are viewing a single comment's thread
view the rest of the comments

[–] sudo@lemmy.today 5 points 5 hours ago (1 children)

Could be a car key fob maybe? CR2032 and buttons could fit on the backside

[–] FRYD@sh.itjust.works 2 points 5 hours ago (1 children)

Maybe, but it would be huge. Most key fobs I’ve seen don’t need mounting screws either. I’m not sure about the battery holder, but any buttons on the other side would likely run through the pcb. I don’t think contact solder would be strong enough for repeated use. There would also be traces somewhere that come from the other side to the controller.

[–] grue@lemmy.world 2 points 4 hours ago* (last edited 2 hours ago)

~~I don't see any merging traces or other aspects of it that don't make sense when looking at the board holistically, so I don't think it's AI.~~ Edit: another commenter pointed out two "pin 1" marks on the biggest chip, so never mind, it's AI. Fuck.

With two microchips with that many pins (maybe a 4+ layer PCB?), it looks too complicated to be a key fob. It also has what looks like a 5-pin header for programming.